Now with parking breaks active, Increase throttle till N1 reaches anywhere between 85% to 95%. *Read and try to remember everything till the "you are back where you left off" or your aircraft might end up in a crashed state if it hits something on the ground, or crashes into the ground after falling from the sky. *Before you continue make sure all flaps and spoilers are retracted, and all flight controls, are centered "press 5", AND PARKING BREAKS ARE ACTIVE!!!! Now set the AP speed to the last speed you presume the aircraft was at where you left off. Using that info, re enter the route plan.Īfter that is done, activate the route plan. Now open the folder where the route plans are stored, and open the one you saved with notepad. Set the crew/cargo/passenger weight accordingly. *Note that for most aircrafts, the fuel levels in fuel tanks are saved in the flight recorder tape, however the passenger/crew/cargo weights are not.įirst start with the same aircraft and sub-aircraft type from any location on the ground. If you are using an MD-11, Boeing 737, DC-10, 747-400, there is a different one marked bellow that you must follow. When you want to start from where you have left off, do the following: Make sure this is done much before or a while after crossing a waypoint. Then save the route plan from the route planer. I have done the following and it works on some aircrafts, or Flight gear will crash on others.īefore you exit, create the save point by first saving the flight recorder tape. Mentris Mentris Posts: 1 Joined: Mon 6:31 am This will be saved when you close the launcher. You can use this in the launcher and paste it into the box at "Settings/Additional Settings". This will copy the exact position and the airport to the clipboard. Var heading = ("orientation/heading-deg",1).getValue() ĬtText("-airport=" ~ airport ~ "\n-lat=" ~ lat ~ "\n-lon=" ~ lon ~ "\n-heading=" ~ heading ~ "\n") įlightgear will remember the code, so you won't have to copy it again. Var lon = ("position/longitude-deg",1).getValue() Var lat = ("position/latitude-deg",1).getValue() Var airport = ("sim/airport/closest-airport-id",1).getValue() Paste this code into the code box by clicking the button "Paste from Clipboard": Open the Nasal Console in Flightgear from the Menu: Debug/Nasal Console. Late reply, but till now I haven't found a simpler solution:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |